![]() If you're unsure if 5.1 is working, I disconnected the L & R speaker wires and retest the audio.Then go back to Step 1 at the very beginning of this guide.Install the "AAF DCH Optimus Audio" from the "Realtek DCH Modded Audio Driver for Windows 10/11 - Including Realtek USB Audio Devices" thread.Go to the "Realtek Digital Output" properties panel and try again.If the "Audio Enhancements" section is missing from the "Realtek Digital Output" properties section try :.Go back to Step 4 in the original guide above and perform all steps again.From "FX Configurator", in the Endpoints selection, select " Realtek Digital Output (Realtek USB Audio) ".Go to the start menu and open "FX Configurator".If the name is different, note down the name, as you'll need it for steps below. Go to the Sound Control panel in Windows and select "Realtek Digital Output" as your default audio and run a speaker test, you should get audio from L & R speakers only.You might get an antivirus warning, you will need to decide on how you want to proceed. Locate the "APO Driver ", and install with only the following options.Install the standard Realtek USB audio drivers, in my case these were "Realtek USB Audio Driver V.2342 For Windows 10/11 64-bit." from the Asus support page for my motherboard.For this you will need the DriverStoreExplorer (by Remove any drivers whose "Provider" is "Realtek", "Dolby", "DTS", "Creative", "A-Volute", "AAF Optimus", etc in the "Sound, Video and Game Controllers", "Extensions", "Software Components" and "Audio Processing Objects" device categories. Uninstall AAF Audio using steps as detailed with the drivers using the standard instructions :īefore installing this modified driver, be sure to remove any and all residues from previous Realtek audio drivers or even if there are residues from previous versions of my mods, if they persist. Creative Sound Blaster Z with DTS Connect, working in 5.1, which I want to remove.OnBoard Audio installed with AAF DCH Optimus Audio driver installed, but not working in 5.1.Logitech Z906 DTS Speakers with SPDIF input.Asus Zenith II Extreme - ALC1220 / S1220 Realtek USB OnBoard Audio.Goal : Use an onboard Realtek USB SPDIF to play DTS over SPDIF to speakers. It should also work on a ALC4080 solution, but I can't check that. ![]() ![]() I would also hope it could be rolled up into an installer such as the AAF pack at some point, as this includes the Realtek USB Driver. They are based on my experience, and I am sure they can be simplified. I would appreciate someone verifying this and that I have got the steps right. BACKUP YOUR PC FIRST and ensure you know how to restore from it. WARNING : This is my own experience, your mileage may vary. Ok, i'm writing this up in the hope that someone will find this helpful, as i've spent 2 years trying to get this to work, and it's only with Zoomer88's divine wisdom, that he talked me through all of this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |